Clean The Puffco Plus — 5 Best Steps for a Fresh Pen
If you want to clean The Puffco Plus properly — whether you just picked one up used or it has been a while since your last deep clean — this Puffco Plus cleaning guide walks you through every part of the device. A clean wax pen hits better, tastes fresher, and lasts longer. This five-step ...
If you want to clean The Puffco Plus properly — whether you just picked one up used or it has been a while since your last deep clean — this Puffco Plus cleaning guide walks you through every part of the device. A clean wax pen hits better, tastes fresher, and lasts longer. This five-step process takes about 15 minutes and uses supplies you likely already have at home.
What You Need to Clean The Puffco Plus
- Q-tips (you will use several)
- Isopropyl alcohol (90% or higher recommended)
- Alcohol prep pads
- Paper towels
- A lighter (for stubborn residue on the ceramic scoop)
The best way to clean wax pen with isopropyl alcohol is to use it on a Q-tip for internal surfaces and on an alcohol prep pad for external parts like the mouthpiece and ceramic scoop. Isopropyl alcohol evaporates quickly, but always allow 30 minutes of dry time before reassembling and using the pen.
Clean The Puffco Plus — 5 Best Steps
- Clean the battery contacts — Grip the pen at the base where the silicone sleeve sits and twist to separate the battery from the body. Dip a Q-tip in isopropyl alcohol and run it around the contact points inside the battery end and on the outer surface. The contacts can collect oil residue over time and cleaning them helps maintain a solid electrical connection. Set the battery aside to dry.
- Clean Puffco Plus atomizer — Unscrew the atomizer from the top section. Dip a fresh Q-tip in isopropyl and gently clean the inside of the ceramic bowl. Note that some discoloration of the ceramic is permanent — this is staining, not dirt, and it will not affect performance. What you are removing is any leftover concentrate residue. Also clean the threads and the electrical contacts on the outside of the atomizer.
- Puffco Plus mouthpiece cleaning — Press down on the silicone mouthpiece tip to release it from the mouthpiece section. For Puffco Plus mouthpiece cleaning, twist an alcohol prep pad into a point and insert it into the mouthpiece tube, spinning it to clean the inside. Wipe the outside of the mouthpiece section with the pad. If you picked up this pen used, give the mouthpiece extra attention.
- Clean the ceramic scoop — The ceramic pick or scoop is used to load concentrate into the bowl. Clean it by wiping with an alcohol prep pad. If there is stubborn hardened residue that does not wipe off, wait until the isopropyl has fully evaporated (about 30–60 seconds) then briefly apply a lighter flame to liquefy the wax before wiping again. Never heat the scoop while it is still wet with isopropyl.
- Dry completely, then reassemble — This is the most important step in this Puffco Plus cleaning guide. Leave all parts out for at least 30 minutes so every trace of isopropyl alcohol evaporates. Inhaling alcohol fumes is harmful — do not rush this step. Once dry: press the mouthpiece back into the mouthpiece section, screw the mouthpiece section onto the atomizer, then twist the battery back onto the base until it is snug.
How Often Should You Clean The Puffco Plus?
Ideally, do a quick clean after every session — a single Q-tip with a little isopropyl in the ceramic bowl takes 30 seconds and prevents heavy buildup. For a full clean wax pen with isopropyl alcohol deep clean (all five steps above), once every few weeks is sufficient for regular users. If you notice a change in flavor or reduced vapor production, that is a sign the atomizer needs attention sooner.
Frequently Asked Questions
Can I soak the Puffco Plus atomizer in isopropyl alcohol?
What percentage isopropyl alcohol should I use?
Why does the Puffco Plus ceramic bowl look stained?
How long should I wait after cleaning before using the pen?
References
Where to Buy
- Use this link to get $30 off your first PuffCo purchase (minimum cart value 150)affiliate
- Alcohol Prep Padsaffiliate
- Cannabis Apparel Store
Some links above are affiliate links. We may earn a commission at no extra cost to you.
Related Posts

Silicon Carbide vs Ruby: When to Use Each in Your Ball Vape
Silicon carbide hits harder than ruby, but ruby is the more forgiving all-rounder. Here is when each one is the right call, why SiC needs a little more skill to run well, and how to get a big, full extraction out of a heat soak without scorching your herb.

How to Customize the YLLVape IH 3.0: Wood Panels, Paint, and Reassembly
YLLVape sent over a fresh set of wood panels for the IH 3.0, so I tore it down, painted the panels, sealed them for the heat, and rebuilt it. Here is how the customization works, what to use so your paint actually survives, and how to make the device your own.

Silicon Carbide vs Ruby Balls: Upgrading Your Ball Vape
Swapping ruby balls for silicon carbide in your ball vape means faster heat-up, more even heat, and fuller extractions. Here's the science, and who it's actually for.
