Add Dried Flowers to Bong: 5 Steps to a Floral DIY Masterpiece

Step 1: Prep the Glass Before You Add Dried Flowers to Bong

Clean the outside of the glass thoroughly with isopropyl alcohol and let it dry completely. Use painters tape to cover the mouthpiece — you do not want resin near where your lips go — and tape off the downstem so it can still be removed later. Proper prep is essential before you add dried flowers to bong surfaces. The mouthpiece and downstem areas should be fully covered.

Step 2: Apply a Base Coat of UV Resin

Using a disposable brush, apply a thin, even base coat of UV resin to the section where you want to add dried flowers to bong glass. Work in sections — start with the neck, then move to the beaker. The base coat helps flowers and pearls adhere properly. Watch out for brush hairs shedding into the resin and remove them with tweezers before curing. Keep the base coat tacky so the flowers will stick.

Step 3: Place Your Flowers and Pearls

While the base coat is still wet, use tweezers to gently place dried flowers and half-pearl beads onto the resin. This is the most creative step when you add dried flowers to bong glass — arrange them however you like, there is no wrong design. Press each flower gently to embed it into the resin. If a flower will not stay, use a tiny drop of super glue to hold it, then resin over it.

Step 4: Apply Top Coat and Cure with UV Light

Once all flowers and pearls are placed, apply another layer of UV resin over the top to seal everything. Move the UV flashlight slowly over each section for 2–3 minutes until the resin is fully cured and hard. Work section by section around the glass to ensure even coverage. Rotate the bong as you cure so all surfaces are reached by the UV light.

Step 5: Seal with Mod Podge Gloss Spray

Once all the resin is cured, give the entire decorated surface a final coat of Mod Podge Gloss Spray as a protective sealant. This adds durability and a beautiful finish to the completed add dried flowers to bong project. Let it dry fully before using. Remove the painters tape from the mouthpiece and downstem, and your floral bong is ready.

Tips for the Best Results

• Wear gloves throughout the entire process — UV resin is toxic before it cures
• Apply thin coats of resin rather than thick ones to avoid drips and uneven curing
• Avoid leaving cured resin in direct sunlight for extended periods — it can yellow over time
• Use good tweezers to place small flowers with precision
• Work in a ventilated space — resin fumes should not be inhaled
• Pre-dried vacuum-packed flowers from Amazon are the easiest option; DIY drying with silica gel is more time-consuming