Best Remove Chlorophyll From Cannabis Tincture Guide — 5 Steps

Before filtering, add 1 teaspoon of activated charcoal to the tincture and stir on a hot plate set to 85°F. Use a spoon — not a metal stir bar, which does not mix it as effectively. Stir for several minutes to allow the charcoal to bind the chlorophyll and other pigments. This prep step is what makes it possible to properly remove chlorophyll from cannabis tincture during the vacuum pass.

Step 2 — Set Up the Filter Cake

Place one filter paper into the Buchner funnel. It should be slightly larger than the funnel’s inner diameter — this ensures it seats tightly against the walls when wet. Prime the filter by wetting it with the same alcohol used to make the tincture (never water). Then add a quarter-inch layer of diatomaceous earth followed by the activated charcoal on top. This layered filter cake is key to learning how to remove chlorophyll from tincture reliably. Without both layers, it is difficult to fully remove chlorophyll from cannabis tincture in a single pass.

Step 3 — Run the Vacuum

Connect the Buchner funnel to the vacuum flask using the stopper, attach the vacuum hose to the side port, and power on the pump. Stir the tincture one final time before pouring it directly onto the filter cake. Watch as the dark green tincture transforms — the alcohol passing through the flask takes on a deep amber color as the chlorophyll is trapped in the filter cake. This is the core of how to remove chlorophyll from tincture via vacuum pressure: the filter cake does the work.

Step 4 — Know When It’s Done

The vacuum filtration is complete when the top of the filter cake looks dry and drips coming through the funnel slow to one every five seconds or more. The vacuum gauge pressure will also start dropping as it becomes easier for air to pass through. At this point, turn off the pump and disconnect the hose before removing the Buchner funnel from the flask.

Step 5 — Test With UV Light

Shine a black light (UV flashlight) onto the filtered tincture. If chlorophyll is still present, it will glow dark burgundy-red under UV. A successful result shows no burgundy glow — just the natural amber color of the clean liquid. This UV test is the simplest way to confirm you have achieved a clean cannabis tincture before use.

Clean Cannabis Tincture — What Changes After Filtration

After filtration, a clean cannabis tincture looks, smells, and tastes noticeably different. Knowing how to remove chlorophyll from tincture means understanding what to expect at this stage. The deep green color becomes golden amber. The harsh plant bitterness and throat irritation are significantly reduced. The tincture is also easier to dose accurately, since it no longer has the heavy plant matter coating the palate that affects perception of dose timing.

The potency is not destroyed by this process. In the video, the final tincture tested at 62 mg/mL via T-Check — measured by diluting 0.5mL of tincture with 2mL of ethanol (a 5× multiplier). The result was still highly effective, which is why knowing how to remove chlorophyll from tincture without sacrificing cannabinoids matters. The activated charcoal targets pigments and lipids — not THC.

Tips and Troubleshooting

• Use the same alcohol to prime the filter — water will cause clogging
• Do not use a metal stir bar to mix the charcoal — use a spoon
• The filter paper must be slightly larger than the funnel’s inner diameter to seal properly
• If the filter cake shows green on the sides, that confirms significant chlorophyll was present
• Running multiple passes through fresh filter cake further purifies the tincture if needed

The goal is to remove chlorophyll from cannabis tincture without reducing potency or introducing contamination. With proper setup, this process takes 15–30 minutes and produces results that are immediately apparent in both color and flavor. A truly clean cannabis tincture made this way is one of the most consistent forms of home cannabis extraction available. Anyone who wants to remove chlorophyll from cannabis tincture without losing potency will find this method produces reliable, repeatable results.